An easy to program decade resistance designed to assist you in rapid electronics prototyping for design engineers, hackers and educational requirements.
This is an easy to program decade resistance designed to assist you in rapid electronics prototyping to support design engineers or education requirements. If you use a breadboard or similar for prototyping for analog circuits, or micro controller circuits like Arduino there will always be that time where you need that specific resistance but do not have it to hand, this is where a programmable resistor comes into its own. This unit can be easily programmed from 0R through to 9.999999MR in 1R steps, its easy to dial in the specific value you need within a few seconds.
It is possible to remove the terminal block connector and replace with 4mm Banana Sockets if you need to – there are already holes in the board to accommodate this.
This content is published under the Attribution-Noncommercial-Share Alike 3.0 Unported license.